 |
 |
 |
|
|
|
[Sponsors] | ||||
October 20, 2008, 01:02
|
Doubt in Inlet Pressure Boundary Condition
|
#1 |
|
Guest
Posts: n/a
|
Hi friends,
I am doing my analysis in blower in that i have to give pressure inlet as 2000pa(Which is below Atmospheric pressure), my doubt is, in operating condition panel its default set as 101325 pa. So could pls some body tell me what value i should give in Operating Pressure and in Pressure Inlet Boundary Condition for my analysis. Thanks for ur time. |
|
|
||
|
October 20, 2008, 02:11
|
Re: Doubt in Inlet Pressure Boundary Condition
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Is this the case of Copmressible Flow ? |
|
|
|
||
|
October 20, 2008, 02:17
|
Re: Doubt in Inlet Pressure Boundary Condition
|
#3 |
|
Guest
Posts: n/a
|
No its incompressible flow only devesh...
|
|
|
|
||
|
October 20, 2008, 03:19
|
Re: Doubt in Inlet Pressure Boundary Condition
|
#4 |
|
Guest
Posts: n/a
|
ok, Now as I know, fluent works on Absolute Pressure. So that if 2000 Pa is Gauge pressure then leave it as a default value of Operating pressure 101325 Pa.
you just put 2000 Pa in Total Gauge pressure at Inlet condition, rest keep it as defalut value. I think that may be helpful. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure Inlet Boundary Condition | Prasad | FLUENT | 6 | April 9, 2013 21:32 |
| Question about pressure inlet boundary condition. | Alina | FLUENT | 1 | November 30, 2007 07:39 |
| doubt on scalar input in pressure boundary | pathak | Siemens | 3 | September 28, 2007 03:20 |
| Pressure Inlet Boundary Condition | Trinity_psu | FLUENT | 0 | June 1, 2005 14:15 |
| Doubt for Boundary Condition | beginner | FLUENT | 1 | April 22, 2003 10:29 |
Linear Mode
