CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   doubt on specifying continuum types (http://www.cfd-online.com/Forums/fluent/49576-doubt-specifying-continuum-types.html)

raghav October 21, 2008 06:45

doubt on specifying continuum types
 
Hi, I'm modelling an axi-symmetric combustion problem. I divided my entire domain into 4 faces and meshed it. I then selected FLUID type for all four faces. While reading the case in FLUENT, it is not showing individual FLUID type that I have created in GAMBIT. Can anyone let me know their suggestions Thankyou

CDE October 21, 2008 20:37

Re: doubt on specifying continuum types
 
Did you specify a FLUID domain for each face with a different name for each?

raghav October 21, 2008 23:46

Re: doubt on specifying continuum types
 
Yes. I did. Can u tell me whether the edges that form the interface between these faces play any role? Should I assign INTEFACE boundary condition to these edges? Thanks for ur prompt reply


All times are GMT -4. The time now is 19:47.