|
[Sponsors] |
November 21, 2008, 02:30 |
error during heat transfer solviing
|
#1 |
Guest
Posts: n/a
|
hello...iam solving forced convection over circular cylinder using FLUENT.iam getting the below given message(1*) while simulation is running.what is that "temperature limited to 1.000000e+00." is it a error ? plz somebody help me in this regard....thankyou in advance
(1*).......... itr no. cont resi u resi v resi energy resi time itr 158292 7.9830e-05 1.5186e-05 5.3959e-06 9.3530e+010:03:27 51 temperature limited to 1.000000e+00 in 141400 cells on zone 2 in domain 1 158293 7.7957e-05 1.4715e-05 5.2087e-06 9.3530e+010:03:22 50 temperature limited to 1.000000e+00 in 141400 cells on zone 2 in domain 1 |
|
November 24, 2008, 01:55 |
Re: error during heat transfer solviing
|
#2 |
Guest
Posts: n/a
|
Yes it would affect your final results do the following checks
1)Check the skewness of your mesh in the region you are getting the limiting values. 2)Check the cp value you have specified and your operating condition of temp. uday |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
flow/heat transfer through heat sink (with fins)? | Pei-Ying Hsieh | Main CFD Forum | 1 | January 26, 2008 07:33 |
I need help whit a error and heat transfer.. | Victor | FLUENT | 1 | September 4, 2007 10:29 |
error estimates in heat transfer problems | srikanth | FLUENT | 0 | August 10, 2007 13:58 |
HEAT-TRANSFER & EXCHANGE HEAT MODEL Problems | Jordi | FLUENT | 1 | March 31, 2006 11:30 |
Heat Transfer Coeff. at Heat Flux Boundary | Rushyen | CFX | 6 | January 18, 2001 06:09 |