How to set up this kind of boundary condition?
 

Hi, everyone. I am using a UDS to modeling the mass transport beween two zones. After the mesh file was read into FLUENT, the common boundary between two zones is auto-transformed into two WALL type boundaries, the name of one is WALL and the other is WAlL_SHADOW. However, on the common boundary, what we know only is that the specified flux of uds is equal but the magnitude of flux is unknown. How to set up this kind of boundary condition?

Thanking you in anticipation.

John

Re: How to set up this kind of boundary condition?
 

Look these tutorials:

http://rapidshare.de/files/40976967/TG.rar.html

Re: How to set up this kind of boundary condition?
 

I forgot the meshes and their respectively tutorials of each part: Here there are:

File TUTFILES.rar (89155 KB):

http://rapidshare.de/files/40977811/TUTFILES.rar.html

Re: How to set up this kind of boundary condition?
 

Hi, Rogerio. Thank you for your reply. However, it is a pity that I cannot free-download your files due to a unknown reason, though the prompt say the file is inexistence. So, could you give me the other link for these files?

BG

John

Re: How to set up this kind of boundary condition?