CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Non-Conformal mesh Problem (http://www.cfd-online.com/Forums/fluent/50118-non-conformal-mesh-problem.html)

dev.... December 23, 2008 09:51

Non-Conformal mesh Problem
 
Hi all, I am trying to mesh a ractangle chamber (2-D geometry). Let's say there is ONE Ractangular chamber, divided by a COMMON EDGE into TWO equal small chamber (say A & B) Now my question is "How shall I divide that geometry by a COMMON EGDE to convert it into sectional (A & B)"(either by SPLIT or SUBSTRACT) so that I can do NON-CONFORMAL meshing on left side portion & right side portion?

What BC I must give at this common EDGE to run the analysis in Fluent

Thanks in Advance. Regards devesh

Svetlin Philipov December 25, 2008 04:59

Re: Non-Conformal mesh Problem
 
Svetlin.Philipov@gmail.com Send a scheme of the problem and explanation

jay December 30, 2008 13:45

Re: Non-Conformal mesh Problem
 
split the face by edge method with connectivity toggled off...


All times are GMT -4. The time now is 09:40.