problem with parallel system
 

hi my freinds I have a quad core computer and I use parallel fluent. My project is dynamic mesh and I have to compile my udf. I can compile and load my udf and make libudf successfuly and then I write my case/data, but each time that I close fluent and again open it and read my case/data this message occures:"error opennig libudf:can't find the path specified". also,I have this problem with my autosaved files. although I am sure that I put my libudf in the same directory with my case/data file. WOULD YOU PLEASE HELP ME TO SOLVE MY PROBLEM? THANKS

Re: problem with parallel system
 

your problem is that you haven't compiled your udf in the parallel computation mode, different from the serial one

Re: problem with parallel system
 

hello,thanks for your attentin