Non-Conformal mesh Problem

December 23, 2008, 08:51

Hi all, I am trying to mesh a ractangle chamber (2-D geometry). Let's say there is ONE Ractangular chamber, divided by a COMMON EDGE into TWO equal small chamber (say A & B) Now my question is "How shall I divide that geometry by a COMMON EGDE to convert it into sectional (A & B)"(either by SPLIT or SUBSTRACT) so that I can do NON-CONFORMAL meshing on left side portion & right side portion?

What BC I must give at this common EDGE to run the analysis in Fluent

Thanks in Advance. Regards devesh

December 25, 2008, 03:59

Svetlin.Philipov@gmail.com Send a scheme of the problem and explanation

December 30, 2008, 12:45

split the face by edge method with connectivity toggled off...

December 23, 2008, 08:51	Non-Conformal mesh Problem	#1
dev.... Guest Posts: n/a	Hi all, I am trying to mesh a ractangle chamber (2-D geometry). Let's say there is ONE Ractangular chamber, divided by a COMMON EDGE into TWO equal small chamber (say A & B) Now my question is "How shall I divide that geometry by a COMMON EGDE to convert it into sectional (A & B)"(either by SPLIT or SUBSTRACT) so that I can do NON-CONFORMAL meshing on left side portion & right side portion? What BC I must give at this common EDGE to run the analysis in Fluent Thanks in Advance. Regards devesh

December 25, 2008, 03:59	Re: Non-Conformal mesh Problem	#2
Svetlin Philipov Guest Posts: n/a	Svetlin.Philipov@gmail.com Send a scheme of the problem and explanation

December 30, 2008, 12:45	Re: Non-Conformal mesh Problem	#3
jay Guest Posts: n/a	split the face by edge method with connectivity toggled off...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
conformal vs. non conformal mesh	otho	Main CFD Forum	2	May 30, 2008 11:11
non conformal mesh	venkatesh	FLUENT	0	September 12, 2005 17:08
non-conformal mesh	modrio	FLUENT	1	July 15, 2005 06:55
Non-conformal mesh question	Jason	FLUENT	1	January 12, 2005 16:17
Non-conformal mesh	Christian	FLUENT	5	February 25, 2002 02:32