CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Error messages (http://www.cfd-online.com/Forums/fluent/50170-error-messages.html)

laisquared January 2, 2009 01:50

Error messages
 
What is the problem with my mesh when this message is shown :"Cannot change rack_inlet to fan because there is only one adjacent cell thread"

Im trying to set a face named "rack inlet" as a fan BC but this message keep appearing.

Help needed. thanks!

zongtwi January 3, 2009 11:28

Re: Error messages
 
Please explain how you created the face in GAMBIT.

laisquared January 5, 2009 01:03

Re: Error messages
 
Hi zongtwi,

I created a block (i.e rack) and meshed the whole volume using "HEX" elements and "Map" type with spacing of 0.2. This block is inside a larger block (i.e room) and i'm trying to simulate flow from the rack within the room.

Do i need to do any Boolean operations? Any steps which i missed out?

Thanks for your response =)


All times are GMT -4. The time now is 03:47.