|
[Sponsors] |
October 4, 2016, 10:51 |
VOF model
|
#1 |
New Member
Attaullah
Join Date: Aug 2016
Posts: 23
Rep Power: 9 |
Hi every one.
I am trying to simulate a venturi scrubber AS SHOWN IN FIGURE. In figure you can see that water is injected from the side nozzles. Air from the main inlet. I have set the BC to velocity inlet for water and air but when i tried to set the velocity for air , the momentum tab does not open for setting of velocity as in fig venturi1. Also the multiphase tab does not open for setting of the volume fraction. Please help me in this regard. Atta |
|
October 5, 2016, 02:06 |
|
#2 |
New Member
Gujarat
Join Date: Oct 2016
Location: Ahmedabad
Posts: 1
Rep Power: 0 |
You have to give mixture velocity and set secondary phase volume fraction as per your requirement.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mixture model + VOF? | blacksoil2012 | Fluent Multiphase | 2 | February 8, 2014 23:59 |
VOF Model or Mixture Model | mems21 | FLUENT | 2 | March 9, 2010 10:37 |
A Problem with setting the time step in VOF model | Le | FLUENT | 2 | July 20, 2006 22:00 |
free surface of VOF and melting model? | wanghong | FLUENT | 3 | March 13, 2006 09:57 |
help needed for vof model | yan | FLUENT | 3 | December 16, 2005 01:17 |