|
[Sponsors] |
March 10, 2009, 03:16 |
DPM ABORT
|
#1 |
Guest
Posts: n/a
|
Hi,
I am getting the following messages when I display Particle Track------ number tracked = 2102, escaped = 3, aborted = 61105, trapped = 0, evaporated = 0, incomplete = 2099 Parallel particle tracking concurrency: 16% I get an ABORT messages saying Can't figure which cell particle is going to -- ABORT Can anyone share their experience with the same. |
|
March 10, 2009, 04:31 |
Re: DPM ABORT
|
#2 |
Guest
Posts: n/a
|
are you getting particle tracks of fuel or not. if yes then dont worry about this message.
|
|
March 10, 2009, 05:06 |
Re: DPM ABORT
|
#3 |
Guest
Posts: n/a
|
Thanks you for your response.
Yes I am able to display the particle tracks. My material is an Inert Particle. I have defined REFLECT for all the walls with coefficient of restitution as 0.3 and there is a rotating domain in my analysis. |
|
March 12, 2009, 03:35 |
Re: DPM ABORT
|
#4 |
Guest
Posts: n/a
|
try to track some particules which are abort and see where...it could be due to your mesh at some point of the geometry
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How can i abort DPM calculations from a UDF | Aris | FLUENT | 0 | April 15, 2008 06:19 |
ABORT in DPM | lisa | FLUENT | 6 | January 20, 2006 02:31 |