|
[Sponsors] |
March 14, 2009, 17:07 |
weirdo mole frac profile
|
#1 |
Guest
Posts: n/a
|
I wrote this message before but somehow it's erased...
I simulate a reforming rxn (endothermic) on cylindrical tube wall and it's converged. when I check the results, I see mole/mass fractions of products increase first then start to decrease along the tube length and vice versa for the reactants. I also look at the temperature, rxn rate profiles. there is nothing seen wrong. temperature and rxn rate decreases along the tube. I simulate volume rxn, too. in this case, everything is going pretty well... rxn: C8H18+ 8H2O-> 8CO+ 17H2 I set H2O as site species. but also I inject steam into the reactor. do you have any idea to solve this problem? thanks in advance... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
weirdo mole frac profile | alp | FLUENT | 1 | February 25, 2009 01:55 |
UDF solution variable for time-averaged mass frac? | A. S. | FLUENT | 0 | May 14, 2007 16:44 |
Pressure outflow w/ species; mass frac. required? | Myth | FLUENT | 2 | September 29, 2006 23:08 |
How to get mole fraction | shuqin | FLUENT | 2 | March 6, 2006 08:37 |
increaseing vol frac after x iterations | Rashmi | FLUENT | 0 | December 13, 2005 21:28 |