Replace Zone -- CFD Online Discussion Forums

April 8, 2009, 12:08	Replace Zone	#1
pipin New Member pipin Join Date: Apr 2009 Posts: 20 Rep Power: 17	Hi, In order to model a problem of valve, i can't use the dynamic mesh method (not enough time and licence for parallele in my school)... i want to change a solid zone into fluid zone during the simulation. i have divided my geometry in 2 and during the simulation i change the solid zone into a fluid zone. i change the wall into interior and i calculate again with this new configuration with a very small time step (10-13 s). Do you know what Fluent do in this zone (what values is it in this zone when i start again the calcul)? and have you got any advice? Thank you Last edited by pipin; April 9, 2009 at 03:50.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 15:33
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 15:02
Error to re-open fluent case file	J.Gimbun	FLUENT	0	April 27, 2006 08:42
how to pass bc from one zone to second zone	Maria	FLUENT	2	March 15, 2004 23:12
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52

All times are GMT -4. The time now is 03:54.