angular velocity in vertical wind turbine

vanni · April 21, 2009, 03:56

Hello guys,

I want to study a new wind turbine with vertical rotational axis.
I think, on the base of the shape of the rotor, that a sliding/dinamic mesh is necessary and I would like to start with a 2D simulation.

Obviously I don’t know the rotational velocity of the rotor at a specific wind velocity.
I think that inertia forces can be neglected at the moment, but I have to take into account the torque end power necessary to generate electrical energy.

The question is how can I setup this simulation?
Can I relate the rotational velocity of the rotating mesh containing the rotor to the torque generated by the wind and to the torque for electrical energy generation? How can I do this? How can I make the flow to move the rotor?

Do you think that this approach is correct?

Thanks in advance
vanni

vanni · April 23, 2009, 02:44

Then,

I think to this formulation for angular velocity ω that must be applied by UDF.

ω t = ωt-1 + [Maer t-1 - M res (ωt-1)] / Irotor * Δt

where:

Maer= torque calculated on rotor due to flow
Mres(ω) = law for torque due to electrical energy power generation
Irotor = rotor Inertia

Do you agree?Vanni

April 21, 2009, 03:56	angular velocity in vertical wind turbine	#1
vanni New Member Join Date: Apr 2009 Posts: 6 Rep Power: 17	Hello guys, I want to study a new wind turbine with vertical rotational axis. I think, on the base of the shape of the rotor, that a sliding/dinamic mesh is necessary and I would like to start with a 2D simulation. Obviously I don’t know the rotational velocity of the rotor at a specific wind velocity. I think that inertia forces can be neglected at the moment, but I have to take into account the torque end power necessary to generate electrical energy. The question is how can I setup this simulation? Can I relate the rotational velocity of the rotating mesh containing the rotor to the torque generated by the wind and to the torque for electrical energy generation? How can I do this? How can I make the flow to move the rotor? Do you think that this approach is correct? Thanks in advance vanni

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Vertical axis wind turbine CFD Analysis	Akhilesh	FLUENT	4	April 13, 2012 16:44
Wind turbine simulation	Saturn	Main CFD Forum	1	June 12, 2006 03:57
Variables Definition in CFX Solver 5.6	R P	CFX	2	October 26, 2004 02:13
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11

April 23, 2009, 02:44		#2
vanni New Member Join Date: Apr 2009 Posts: 6 Rep Power: 17	Then, I think to this formulation for angular velocity ω that must be applied by UDF. ω t = ωt-1 + [Maer t-1 - M res (ωt-1)] / Irotor * Δt where: Maer= torque calculated on rotor due to flow Mres(ω) = law for torque due to electrical energy power generation Irotor = rotor Inertia Do you agree?Vanni