|May 8, 2009, 16:19||
ask for help about flame simulation by fluent
Join Date: May 2009
Posts: 2Rep Power: 0
I have a problem while i am simulating the laminar flame with fluent.
The temperature increases after iteration, but when the temperature goes to a certain value, it begins to drop to a very low value.
I refine the grid, change the initial temperature, but nothing help.
could anyone help to give me some advice? thank you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Simulation of savonius rotor in Fluent||Kirit||FLUENT||0||October 20, 2008 12:05|
|mixing coloured dye simulation using FLUENT||fadhil||FLUENT||0||August 24, 2008 22:11|
|which s/w for turbine simulation, Fluent/ CFX ?||Parag||FLUENT||0||March 8, 2007 03:28|
|Flame simulation||Mark||FLUENT||1||July 16, 2002 03:34|
|New Fluent Remote Simulation Facility||Paul Bemis||FLUENT||8||July 2, 2002 09:18|