Modelling of 2D Wind Turbine Blade (HAWT)

Richeom · August 10, 2010, 10:57

I am relatively new to FLUENT and having difficulty modelling fluid flow over my 2D wind turbine blade geometry.

I see that in FLUENT>Problem Setup>Boundary Conditions, I can select that a particular part be rotating. This seems ideal for me, as I can then set the blade to be moving and adjust wind speed. However, given the geometry that I have, an appropriate axis of rotation would be in the negative direction on the Z axis. Which isn't available to me (I assume because my mesh is 2D).

Can you suggest to me how I might be able to let FLUENT know that my blade is rotating. I don't want to do this in 3D.

Would it be more accurate to use the vector addiction of the wind speed and the blade speed or would this be completely inaccurate?

jack1980 · August 11, 2010, 04:18

Hi,

I'm afraid this option might not be what you are looking for. Setting a moving wall will only adjust the zero slip boundary condition of the wall, it will not actually move or rotate your geometry.

For a rotating geometry you might use a sliding grid.

Good luck!

August 10, 2010, 10:57	Modelling of 2D Wind Turbine Blade (HAWT)	#1
Richeom New Member Richard Morris Join Date: Jul 2010 Posts: 9 Rep Power: 15	I am relatively new to FLUENT and having difficulty modelling fluid flow over my 2D wind turbine blade geometry. I see that in FLUENT>Problem Setup>Boundary Conditions, I can select that a particular part be rotating. This seems ideal for me, as I can then set the blade to be moving and adjust wind speed. However, given the geometry that I have, an appropriate axis of rotation would be in the negative direction on the Z axis. Which isn't available to me (I assume because my mesh is 2D). Can you suggest to me how I might be able to let FLUENT know that my blade is rotating. I don't want to do this in 3D. Would it be more accurate to use the vector addiction of the wind speed and the blade speed or would this be completely inaccurate?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
please help in simulating a wind turbine blade in 6 DOF ????....	usman naseer	Main CFD Forum	2	March 10, 2016 02:53
Can I use Turbogrid to mesh a wind turbine blade?	Henry Liu	CFX	10	November 10, 2011 05:41
Modelling of 2D Wind Turbine Blade (HAWT)	Richeom	FLUENT	0	July 29, 2010 11:57
Wind Turbine Blade Geometry	SeanieB	Main CFD Forum	0	November 27, 2009 10:18
Wind Turbine Modelling	Neil Campbell	Main CFD Forum	1	November 10, 1998 19:03

August 11, 2010, 04:18		#2
jack1980 Senior Member Jouke de Baar Join Date: Oct 2009 Posts: 127 Rep Power: 16	Hi, I'm afraid this option might not be what you are looking for. Setting a moving wall will only adjust the zero slip boundary condition of the wall, it will not actually move or rotate your geometry. For a rotating geometry you might use a sliding grid. Good luck!