|
[Sponsors] |
Know variables at interior but not inlet in film cooling- How to approach? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 8, 2009, 06:25 |
Know variables at interior but not inlet in film cooling- How to approach?
|
#1 |
New Member
Prashanth
Join Date: Apr 2009
Posts: 19
Rep Power: 17 |
Hi all
I am trying to model a film cooling case in 3D. I know the temperature and velocity at the cooling holes entry from the blowing ratio. But in my domain, the cooling holes entry are 'Interior' faces and hence I cant set any BC here. I do not know the temperature and velocity at which flow enters my coolant plenum such that the desired T and v are obtained at the coolant holes entry. Is there any way I can specify the values expected at these interior faces? I was thinking of solving my problem backwards with film cooling holes entry as inlet and the coolant plenum entry as exit so I get all values of same magnitude but in negative. Is this right? Thanks Regards, Prashanth |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turbine film cooling simulation | Lorenzo | CFX | 1 | September 9, 2010 12:13 |
Unbelievably high velocity magnitudes in film cooling - HELP! | shankara.2 | FLUENT | 0 | June 1, 2009 22:43 |
film cooling problem | radu | FLUENT | 1 | December 11, 2007 05:09 |
Meshing Film cooling geometry | Janendra Telisinghe | CFX | 1 | January 31, 2006 06:16 |
loss of cooling film ? | lhb | Main CFD Forum | 0 | January 12, 2002 06:11 |