|June 10, 2009, 12:29||
normal temperature gradient on a boundary
Join Date: Jun 2009
Posts: 2Rep Power: 0
I impose temperature on my wall.
After convergence, I would like to post process my results :
I would like to get normal temperature gradient on a boundary and on a surface (plane created in fluent with surface => plane tools)
C_T_G macro is not adapted because it gives celle temperature gradient and my surface is constituted by facets
but F_T_G doesn't exist.
How can I manage ?
I shall be very grateful if you would take a little time to look at it...
Best regards, Sandrine.
|Thread||Thread Starter||Forum||Replies||Last Post|
|inlet velocity boundary condition||murali||CFX||5||August 3, 2012 08:56|
|Errno 24 linux||ivanwhlau||OpenFOAM Running, Solving & CFD||6||July 1, 2009 10:16|
|temperature normal gradient on a boundary||Sandrine||Main CFD Forum||2||June 10, 2009 16:34|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|