|
[Sponsors] |
July 4, 2009, 05:39 |
Fluent
|
#1 |
New Member
anindita
Join Date: Jun 2009
Posts: 4
Rep Power: 16 |
HI. IM TRYING TO SIMUL;ATE THE CASE AS TO HOW THE VARIATION OF CAMBER WILL AFFECT THE LIFT AND THE EARLY OR LATE OCCURENCE OF STALL. SO I NEED A GEOMETRY OF 3D WING OR IF YOU COULD SEND ME A THREE D MESH TO PROCEED WITH THE SAME AS WELL AS THE METHOD TO PROCEED WITH IT I FLUENT.IT SHALL BE CONVENIENT IF THE GEOMETRY CREATION AND MESHING STEPS ARE ALSO GIVEN.MY ID IS aeroanindita@gmail.com .thank you
|
|
July 4, 2009, 11:26 |
|
#2 |
Member
Akour
Join Date: May 2009
Posts: 79
Rep Power: 16 |
a little bit of advice: when you are posting on forums it is generally better to show that you have tried something and have run into problems, rather than demanding something from the users of the forum, i guarantee you it will get you where u want to be a lot faster. but unfortunately i dont have a 3d mesh of a wing...i suggest using something like solid works or CATIA and importing in to GAMBIT for meshing operations...
__________________
akour |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |
FLUENT versions ... | Gautam | FLUENT | 3 | November 1, 2007 10:49 |
Run Fluent in batch mode | Shengping LUO | FLUENT | 2 | October 24, 2000 05:42 |