|July 28, 2009, 15:07||
Is the cell count causing error?
Join Date: Jun 2009
Posts: 18Rep Power: 8
I have a case were I meshed a geometry with 4.7 million cells. I meshed in Gambit, and the solver I am using is Fluent 5.
Once I am ready to start the iteration process, I get an Warning that reads,
out of memory. malloc.storage: unable to malloc Velocity SA.
About how many cell is to much? This must depend obviously on a systems capacity, for 2.33GHz, 64bit, 16GB RAM, What would be a resonable cell count without running into trouble?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Error: Dynamic-Mesh failed. -ve cell vol Detected||Manoj Kumar||FLUENT||2||April 27, 2014 17:04|
|Integrated conjugate heat transfer solver in OpenFOAM||hjasak||OpenFOAM Running, Solving & CFD||168||June 27, 2013 01:56|
|Installation problem with GCC||Norma McKee (Mckee)||OpenFOAM Installation||10||March 4, 2007 08:09|
|user subroutine error||CFDUSER||CFX||2||December 9, 2006 07:31|
|Compilation Error....||Arnab||CD-adapco||4||September 12, 2004 15:54|