 |
 |
 |
|
|
|
[Sponsors] | ||||
July 28, 2009, 15:07
|
Is the cell count causing error?
|
#1 |
|
New Member
Edgard Espinosa
Join Date: Jun 2009
Posts: 18
Rep Power: 16  |
I have a case were I meshed a geometry with 4.7 million cells. I meshed in Gambit, and the solver I am using is Fluent 5.
Once I am ready to start the iteration process, I get an Warning that reads, out of memory. malloc.storage: unable to malloc Velocity SA. SEE IMG: http://i1009.photobucket.com/albums/...luentError.jpg About how many cell is to much? This must depend obviously on a systems capacity, for 2.33GHz, 64bit, 16GB RAM, What would be a resonable cell count without running into trouble? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Integrated conjugate heat transfer solver in OpenFOAM | hjasak | OpenFOAM Running, Solving & CFD | 172 | April 13, 2023 00:42 |
| Error: Dynamic-Mesh failed. -ve cell vol Detected | Manoj Kumar | FLUENT | 2 | April 27, 2014 17:04 |
| Installation problem with GCC | Norma McKee (Mckee) | OpenFOAM Installation | 10 | March 4, 2007 07:09 |
| user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
| Compilation Error.... | Arnab | Siemens | 4 | September 12, 2004 15:54 |
Linear Mode
