Prevent an iteration after the convergence

Deus · August 12, 2009, 05:26

Hi everybody,
I'm new in fluent and I have a problem. I use fluent 6.3 in batch with a journal in input.
I must stop the calculation after each iteration and then use the command iterate.
I noticed that when the convergence is reached, the command "iterate" still works.
Is there a option which avoid the iterations after the convergence ?

Thank you for your help.

solefire · August 12, 2009, 05:31

It happens to me also. But just let it go, and it will stop soon!

Deus · August 12, 2009, 05:50

Are you Sure ?
The convergence is reached after the iteration 9.
Then I try the command "it 1" many times, and it still works after 100 iterations.

August 12, 2009, 05:26	Prevent an iteration after the convergence	#1
Deus New Member Join Date: Aug 2009 Posts: 2 Rep Power: 0	Hi everybody, I'm new in fluent and I have a problem. I use fluent 6.3 in batch with a journal in input. I must stop the calculation after each iteration and then use the command iterate. I noticed that when the convergence is reached, the command "iterate" still works. Is there a option which avoid the iterations after the convergence ? Thank you for your help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to increase "Newton Pressure Iteration Limit"	kus	CFX	9	April 21, 2013 01:54
Convergence of CFX field in FSI analysis	nasdak	CFX	2	June 29, 2009 01:17
Parallel runs slower with MTU=9000 than MTU=1500	Javier Larrondo	FLUENT	0	October 28, 2007 22:30
Defect correction and convergence	ganesh	Main CFD Forum	4	June 30, 2006 14:20
Heat exchanger problem	chiseung	FLUENT	16	October 20, 2001 04:36

August 12, 2009, 05:31		#2
solefire Member CJ Join Date: Jun 2009 Posts: 34 Rep Power: 16	It happens to me also. But just let it go, and it will stop soon!

August 12, 2009, 05:50		#3
Deus New Member Join Date: Aug 2009 Posts: 2 Rep Power: 0	Are you Sure ? The convergence is reached after the iteration 9. Then I try the command "it 1" many times, and it still works after 100 iterations.