|
[Sponsors] |
August 12, 2009, 05:26 |
Prevent an iteration after the convergence
|
#1 |
New Member
Join Date: Aug 2009
Posts: 2
Rep Power: 0 |
Hi everybody,
I'm new in fluent and I have a problem. I use fluent 6.3 in batch with a journal in input. I must stop the calculation after each iteration and then use the command iterate. I noticed that when the convergence is reached, the command "iterate" still works. Is there a option which avoid the iterations after the convergence ? Thank you for your help. |
|
August 12, 2009, 05:31 |
|
#2 |
Member
CJ
Join Date: Jun 2009
Posts: 34
Rep Power: 16 |
It happens to me also. But just let it go, and it will stop soon!
|
|
August 12, 2009, 05:50 |
|
#3 |
New Member
Join Date: Aug 2009
Posts: 2
Rep Power: 0 |
Are you Sure ?
The convergence is reached after the iteration 9. Then I try the command "it 1" many times, and it still works after 100 iterations. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 01:54 |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 01:17 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 22:30 |
Defect correction and convergence | ganesh | Main CFD Forum | 4 | June 30, 2006 14:20 |
Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 04:36 |