|
[Sponsors] |
August 27, 2009, 11:50 |
Simulating a duct
|
#1 |
New Member
David Garcia
Join Date: Aug 2009
Posts: 1
Rep Power: 0 |
Hello!
I am simulating a Formula car in Fluent 6.3 and i have problems with the sidepots (ducts). At this moment the inner sidepot geometry isn’t designed and I want to simulate only the external geometry. My problem is that I don’t know how to set that the mass flow in the intake of the duct is equal to the outtake mass flow. If it is possible, I want to know how to put a loss coefficient because of the inner radiator. Thanks! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fabric Duct Modeling | Dan | FLUENT | 0 | June 30, 2008 16:00 |
Total pressure increase in the diverging duct | shiv | Siemens | 3 | February 1, 2008 04:39 |
Turbulent flow in a rectangular duct foam vs fluent | atzaru | OpenFOAM Pre-Processing | 7 | February 13, 2007 15:42 |
modelling fuel cell duct in fluent | rajesh kumar tippabhotla | FLUENT | 2 | October 7, 2004 13:04 |
flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 18:49 |