|August 29, 2009, 10:29||
need help with manifold analysis in fluent
Join Date: Aug 2009
Posts: 5Rep Power: 8
I'm simulating exhaust manifold of a car engine. I meshed the model without errors.. The part where i'm struck is the boundary conditions..
I really need some guidance for modeling,
The recurring boundary conditions based on the crank angle and the firing order.. Like at a certain crank angle based on the firing order, the boundary conditions have to change to other manifold. like the manifold which was inlet at some time should change as a wall after some crank angle, and the appropriate manifold should be an inlet..
this is where i'm struck... about how to write the recurring boundary conditions to a manifold based on crank angle and firing order..
i really need help with this plzz..
|Thread||Thread Starter||Forum||Replies||Last Post|
|Parametric analysis in fluent||Nikhil||FLUENT||4||November 22, 2010 06:53|
|Manifold Analysis||Vijay||FLUENT||0||May 20, 2008 00:05|
|Analysis of 2D airfoils in Fluent||Himanshu||Main CFD Forum||1||January 11, 2006 17:07|
|non-dimensional analysis in Fluent||Endee||FLUENT||8||September 7, 2005 16:16|
|How does FLUENT fair in absolute heat transfer analysis||Steve Aboagye||Main CFD Forum||1||August 31, 1998 12:12|