Home > Forums > FLUENT

Separating wall

Mark Forums Read

Reply

September 18, 2009, 06:08	Separating wall	#1
Agovale46 New Member Alessandro Rosa Join Date: Sep 2009 Posts: 4 Rep Power: 5	hello guys. In the thread before , i forget to say i have anotherone problem. After the grid importation, it apears the message "Separating wall zone 5 into zones 5 and 18 "too. What does it mean? is it a problem to do the simulation?

Reply

Tags

separating wall

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent3DMeshToFoam	simvun	OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...	48	May 14, 2012 05:20
modeling coduction in thin wall separating two flu	mohamed ismaiel	FLUENT	0	December 25, 2008 15:12
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
help with wall functions	Nick Georgiadis	Main CFD Forum	4	February 20, 2000 17:07

All times are GMT -4. The time now is 05:01.