|
[Sponsors] |
September 23, 2009, 12:17 |
plz helppppppp
|
#1 |
New Member
saleh
Join Date: Jun 2009
Posts: 4
Rep Power: 16 |
in mixing tank for example near the impeller energy dissipation rate is very high .i want to have volume this place but this volume is non uniform .i want to have flow rate and volume ,and mass wiethed average of dissipation rate of this place.i went to iso-clip and chose the range of high dissipation rate and created the surface and then went to integral surface but i think i shuold have this place in integral volume\but this ragion didnt come to the integral volume.how i shoud have information (such as flow rate )about non uniform volume in fluent.plz help me.thx
|
|
September 23, 2009, 17:40 |
|
#2 |
New Member
Join Date: Apr 2009
Posts: 19
Rep Power: 0 |
What was wrong with a surface integral for a mass flow rate? It should work regardless of the composition of species flowing through.
As for volume integral and the region not showing up, that sounds like you may have a mistake in your geometry generation where you're not closing off that region as its own entity correctly, or maybe you specified the wrong BC type for it in Fluent, e.g. interior... |
|
September 24, 2009, 01:16 |
|
#3 |
New Member
saleh
Join Date: Jun 2009
Posts: 4
Rep Power: 16 |
thx for reply me.is it possible to have ur email?.i want to show the non uniform volume to u.thx
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plz help me "creation IC engine Geometry" | khalaf | FLUENT | 8 | September 28, 2016 01:10 |
plz help its urgent | garima chaudhary | FLUENT | 0 | September 25, 2007 05:28 |
Need Help plz.: Aerodynamics of the Kitewing | Manuel Bär | Main CFD Forum | 0 | August 1, 2007 07:23 |
plz ......help me out.....************************ | krishna | FLUENT | 2 | January 10, 2007 02:53 |
help plz! problems in filling times : new user | shankar | FLUENT | 0 | July 24, 2003 12:58 |