 |
 |
 |
|
|
|
[Sponsors] | ||||
October 8, 2009, 14:59
|
boundary conditions for building ventilation
|
#1 |
|
New Member
rahul
Join Date: Oct 2009
Posts: 10
Rep Power: 16  |
hello everyone ,
i am taking a case of builiding room with two cross windows and i want that ambient air flows naturally from openings than which type of boundary condition should i take? And if i want air flow analysis at inlet and outlet than which condition will touch the real condition. Is it favourable to model building surrounded by bigger volume and define boundary condition on that volume and than analyse that. Please anyone tell me..... |
|
|
|
|
|
October 12, 2009, 02:50
|
|
#2 | |
|
Member
anonym
Join Date: Mar 2009
Posts: 65
Rep Power: 17 |
Quote:
If you have the possibility, take your building into a "wind tunnel". It should be at least 5-6 times bigger than your building. |
||
|
|
|
||
|
October 13, 2009, 01:28
|
|
#3 | |
|
New Member
rahul
Join Date: Oct 2009
Posts: 10
Rep Power: 16 |
Quote:
|
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with boundary conditions for a lowRekOmegaSST turbulence model | cfdmarkus | OpenFOAM Running, Solving & CFD | 16 | November 14, 2011 04:44 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
| Pressure boundary conditions | Lionel S. | Main CFD Forum | 1 | August 24, 2007 18:03 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |
Linear Mode
