 |
 |
 |
|
|
|
[Sponsors] | ||||
October 26, 2009, 23:43
|
sharpness of the interface.
|
#1 |
|
New Member
Deepti.R.Krrishnan
Join Date: Jun 2009
Posts: 4
Rep Power: 16  |
hi
i am working on the mesh generation of a 2d falling box. i recreated the mesh. during the running of the program i find that the interface between air and water is fuzzy. this happens even at the start of the run. can u let me know how to get a sharp interface(atleast during the first few iteration)? thanks deepti |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Solid-fluid Interface question | shankara.2 | ANSYS Meshing & Geometry | 2 | September 14, 2011 12:49 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
