|
[Sponsors] |
Could you help me to interpretate the results? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 10, 2009, 10:55 |
Could you help me to interpretate the results?
|
#1 |
Member
Li
Join Date: Mar 2009
Posts: 54
Rep Power: 17 |
Hi everyone,
I am running a ventilation system in a room. The air was supplied from the ceiling and exausted from the outlet, see the velocity distribution in attachment. The several squares were used to monitor the heat source specified as temperature boundary condition. When I looked at the distribution of turbulence viscosity ratio, I can see that it didn't distribute smoothly. Is this a problem of the mesh? BTW, I used Fluent 6.3 and SST model. Thanks a lot. Li |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM - Validation of Results | Ahmed | OpenFOAM Running, Solving & CFD | 10 | May 13, 2018 18:28 |
Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 11:33 |
wind tunnel results vs fluent | pixie | Main CFD Forum | 1 | August 20, 2009 08:02 |
Problems with repeating results | Lee | Siemens | 4 | May 26, 2006 03:39 |
benchmark results | stefan | Siemens | 3 | September 10, 2001 09:48 |