Orifice meter

October 1, 2003, 09:16

Hi,

I am have been doing simulation of Flow in Orifice meter. The discharge coefficient I get using Fluent for Re of 40000 is around 0.66. The actual discharge coefficient is around 0.61. I tried refining the grid in the shear layer and modifying the solver, but I couldnt get it below 0.65.

Any help would be greatly appreciated.

Regards Murali.

October 9, 2003, 07:03

Hi!

You have a very low Re number. What turbulence model are you using?

You shoul also know that cfr (RANS) will usually not give you exactly the same reults as experiment. What you should worry about is if your reults have the same trend as experimental ones (offset between cfd and experiment is very common)

Best regards

MATEUS

shefali · November 14, 2009, 14:04

Hi
I am also trying to verify the orifice meter problem (with pressure tappings located at D length units upstream and D/2 length units downstream using IDEAS-ESC software. I also overestimated the Cd by 0.07 (I got 0.68). When I am trying to refine the mesh, I am getting an error saying
"Fatal Overflow in linear flow solver".
How to address this problem?

shefali

October 1, 2003, 09:16	Orifice meter	#1
Murali Guest Posts: n/a	Hi, I am have been doing simulation of Flow in Orifice meter. The discharge coefficient I get using Fluent for Re of 40000 is around 0.66. The actual discharge coefficient is around 0.61. I tried refining the grid in the shear layer and modifying the solver, but I couldnt get it below 0.65. Any help would be greatly appreciated. Regards Murali.

October 9, 2003, 07:03	Re: Orifice meter	#2
mateus Guest Posts: n/a	Hi! You have a very low Re number. What turbulence model are you using? You shoul also know that cfr (RANS) will usually not give you exactly the same reults as experiment. What you should worry about is if your reults have the same trend as experimental ones (offset between cfd and experiment is very common) Best regards MATEUS

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Flow meter Design	CD adapco Group Marketing	Siemens	3	June 21, 2011 08:33
Need help on simulation of incompressible flow in an orifice meter	mep10jl	FLUENT	0	November 18, 2010 19:25
lenght and number of nodes for an orifice meter flow problem - k-eps model	fofo	FLUENT	0	November 15, 2009 03:49
Flow past orifice	aurel	Main CFD Forum	0	January 27, 2009 06:46
Orifice Flow	Prateep Chatterjee	FLUENT	4	February 23, 2001 14:59

November 14, 2009, 14:04		#3
shefali New Member Shefali Join Date: Aug 2009 Posts: 4 Rep Power: 16	Hi I am also trying to verify the orifice meter problem (with pressure tappings located at D length units upstream and D/2 length units downstream using IDEAS-ESC software. I also overestimated the Cd by 0.07 (I got 0.68). When I am trying to refine the mesh, I am getting an error saying "Fatal Overflow in linear flow solver". How to address this problem? shefali