CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Centrifugal Pump 2D and 3D

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   September 28, 2007, 10:26
Default Centrifugal Pump 2D and 3D
  #1
Glen
Guest
 
Posts: n/a
I have tried to simulate in interaction between impeller and volute using several methods, with varied success.

In 2D, I modelled the cross section of a small centrifugal pump. I set up the suction nozzle, impeller region and volute region up as three different faces and meshed them.

After exporting to Fluent, I set up the impeller region as a rotating referrence frame at 500rpm. This provides sensible results for some models, but not all. Sometimes the solution will not converge. In these cases I used water as the fluid, had a velocity inlet at the suction nozzle and a pressure outlet at the discharge of the volute set to 0 Pa.

With three dimensions I tried applying a similar method, with little success. The fluid being moved by the impeller is unable to progress to the volute.

Any help would be greatly appreciated.
  Reply With Quote

Old   February 18, 2010, 02:18
Default
  #2
New Member
 
@p N
Join Date: Jan 2010
Location: United States
Posts: 27
Rep Power: 16
yvonne is on a distinguished road
Have you tried giving mass flow inlet and pressure outlet?? Also check if u are giving flowrate in proportion to rpm
yvonne is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On



All times are GMT -4. The time now is 02:03.