|March 3, 2010, 20:19||
reading velocity profile at each time step
Join Date: Dec 2009
Posts: 4Rep Power: 7
i am simulating a 2D flow in an axisymmetric tube.
there are two meshed tubes, one straight and another converging-diverging.
(that is because we cannot know the outflow conditions of the straight tube and also some flow data from it are needed for presentation)
during steady-state simulations, i was writing the outflow velocity profile of the first and then feeded it as inflow profile to the second.
(File --> Write --> Profile... & File --> Read --> Profile).
any ideas how to do it, for each time step, during transient simulation ???
using a UDF or by Executing Commands after each time step?
and what possible structure would this have?
thank you in advance...
|read profile, time step, velocity profile|
|Thread||Thread Starter||Forum||Replies||Last Post|
|HELP! time step too small?||meangreen||Main CFD Forum||5||August 27, 2009 12:32|
|DPM UDF particle position using the macro P_POS(p)[i]||dm2747||FLUENT||0||April 17, 2009 01:29|
|Modeling in micron scale using icoFoam||m9819348||OpenFOAM Running, Solving & CFD||7||October 27, 2007 00:36|
|Transient simulation not converging||skabilan||OpenFOAM Running, Solving & CFD||12||September 17, 2007 17:48|
|unsteady calcs in FLUENT||Sanjay Padhiar||Main CFD Forum||1||March 31, 1999 12:32|