 |
 |
 |
|
|
|
[Sponsors] | ||||
May 31, 2011, 15:11
|
help
|
#21 |
|
New Member
majid
Join Date: May 2011
Posts: 3
Rep Power: 14  |
hi,
I am preparing a job in the si cylinder but i don't have the 3d geometry for simulate them in fluent i can't found it any were. please if you can help ! |
|
|
|
|
|
February 6, 2013, 03:19
|
How can i defined inlet port in a 3D dynamic mesh model inside a cylinder
|
#22 |
|
New Member
Mohab Gad
Join Date: Jan 2013
Posts: 2
Rep Power: 0 |
Hi all;
Am working at 3D dynamic mesh inside a cylinder and am using inlet and outlet ports am always getting negative volume i am using remeshing, layering and smoothing i tried to defined the port as interface, change the zone type and even copy the BC i always get nothing am starting from BDC i don't know what to do any more ...... can anyone help please. 
|
|
|
|
|
|
 |
| Tags |
| remeshing |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some questions about mesh updating in dynamic mesh technique | lzgwhy | Main CFD Forum | 0 | June 14, 2009 08:01 |
| dynamic mesh prob inside the cylinder | kantharao | FLUENT | 0 | May 30, 2008 06:36 |
| Cannot preview the dynamic mesh | sam | FLUENT | 4 | May 26, 2005 06:58 |
| Help: Is it possible to use dynamic mesh model and | Valery Ponyavin | FLUENT | 1 | September 20, 2003 14:18 |
| Dynamic mesh & Multiphase | Alexandre | FLUENT | 3 | September 13, 2002 11:35 |
Linear Mode
