|
[Sponsors] |
April 1, 2010, 15:16 |
2-Phase flow visualization
|
#1 |
Member
Pranab N Jha
Join Date: Nov 2009
Location: Houston, TX
Posts: 86
Rep Power: 16 |
Hi,
I am a new learner of Fluent. I simulated two phase flow with air and water (split inlet). How can I visualize the two phases better apart from looking at the contours of the volume fraction. I have attached pics from my simulation below. I do not want to increase the mesh density as it increases my computation time. Thanks, Pranab |
|
April 1, 2010, 18:19 |
|
#2 |
Senior Member
Sebastian Gatzka
Join Date: Mar 2009
Location: Frankfurt, Germany
Posts: 729
Rep Power: 20 |
If you just visualize one contour surface for VOF-variabel = 0.5 you will get the interface.
__________________
Schrödingers wife: "What did you do to the cat? It's half dead!" |
|
April 4, 2010, 10:18 |
|
#3 |
Senior Member
Jouke de Baar
Join Date: Oct 2009
Posts: 127
Rep Power: 16 |
also you can define a new iso-surface for vof = 0.5. You can then, for example, make a contour plot of the z-coordinate on this surface
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
behavior of two phase flow in a pipe | Sonia84 | FLUENT | 5 | September 17, 2013 17:31 |
Two phase flow with condensation | Sunnie | FLUENT | 0 | May 31, 2009 11:02 |
compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 2, 2003 00:32 |
Problem on boundry of two phase flow | youngan | CFX | 0 | June 30, 2003 03:32 |