different conditions for multiple periodic zones
I'm dealing with a fin-tube heat exchanger simulation.
I isolated and meshed a small unity (3D) of the finned pack.
The resulting domain is a parallelepiped.
I imposed symmetry on the left and right side.
Then I created 2 distinct conformal periodic zones: inlet+outlet and upper+lower face.
Is there a way to set different periodic parameters (i.e. deltap, mass flow rate) to each of the two periodic zones?
Using the periodic conditions dialog box, the same condition is assigned to both periodic zones..
Any help would be really appreciated!!
|All times are GMT -4. The time now is 21:43.|