|
[Sponsors] |
December 2, 2018, 06:26 |
pressure-based flow
|
#1 |
Member
Join Date: Aug 2018
Posts: 85
Rep Power: 7 |
Hi,
I have modeled a 2D plate, its inlet is periodic and is not velocity inlet. I set the g-value for its pressure based flow, \rho= 1 and \mu = 0.01 but there was no result. I initialize it by giving value to x=1 it showed result but velocity profile and Re number depend on the value of x rather than the value of g. How can I get flow field and Re dependent on g? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
Pressure Driven Supersonic Flow in Converging-Diverging Nozzle | cdm | OpenFOAM Running, Solving & CFD | 7 | August 28, 2019 01:37 |
Reversed flow using pressure inlet and outlet? | here_for_help | FLUENT | 0 | September 28, 2018 15:20 |
back pressure at exit for supersonic flow | BigFrank | FLUENT | 6 | April 24, 2014 15:13 |
reference pressure and compressible flow | bingo10 | CFX | 0 | September 11, 2013 07:32 |