Combustion SImulation in Fluent
 

hi everyone !

Am performing a non-premixed combustion simulation of gas turbine engine in fluent. its a 30 deg axisymmetric 3D model. i was trying to run the continuous phase. but i get the following error.
Temperature limited to 1 in zones 2 and 3

and the solution is converged in 1 iteration.

i know its wrong. please someone help me with this. also it would be of immense help if someone can provide me with some useful information in running combustion modelling in fluent.

Hi,
firstly, carefully check the BCs set up and the material properties..;)