Vof boundary setting

EYITAYOAFOLABI · June 4, 2010, 09:42

l am working on a stratified flow of air-water. can someone enlighten me on how to set up the boundary condition? l want both air and water to enter through a single inlet and each of the fluid comes out at different pressure outlet.
the flow is highly turbulent and l will like to use RSM together with VOF.
any suggestion, please?

pranab_jha · June 7, 2010, 15:13

Hi,

You can divide the inlet into two parts (as you may like) to get the inlet BC. Keep in mind to specify the volume fraction of water (supposing as the secondary fluid) to be 0 at the air inlet and =1 at the water inlet so that you get only air inflow or only water inflow from the inlets.
For RSM, you will have to calculate the initial pilot values for various parameters (eg k, e, w, etc) depending on which model you choose. This step is critical. I also struggle sometimes with these. You can get some help on these if you go to the wiki section of this website.

Cheers,
Pranab

P.S.: Did not get the wink at the end!

June 4, 2010, 09:42	Vof boundary setting	#1
EYITAYOAFOLABI New Member EYITAYO AFOLABI Join Date: Apr 2009 Posts: 10 Rep Power: 17	l am working on a stratified flow of air-water. can someone enlighten me on how to set up the boundary condition? l want both air and water to enter through a single inlet and each of the fluid comes out at different pressure outlet. the flow is highly turbulent and l will like to use RSM together with VOF. any suggestion, please? Last edited by EYITAYOAFOLABI; June 4, 2010 at 10:51.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary condition setting for non-premixed combustion using reactingFoam	skyopener	OpenFOAM	0	May 23, 2010 22:55
VOF setting for ship's hull study	simone b.	FLUENT	0	December 1, 2008 11:34
A Problem with setting the time step in VOF model	Le	FLUENT	2	July 20, 2006 22:00
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

June 7, 2010, 15:13		#2
pranab_jha Member Pranab N Jha Join Date: Nov 2009 Location: Houston, TX Posts: 86 Rep Power: 16	Hi, You can divide the inlet into two parts (as you may like) to get the inlet BC. Keep in mind to specify the volume fraction of water (supposing as the secondary fluid) to be 0 at the air inlet and =1 at the water inlet so that you get only air inflow or only water inflow from the inlets. For RSM, you will have to calculate the initial pilot values for various parameters (eg k, e, w, etc) depending on which model you choose. This step is critical. I also struggle sometimes with these. You can get some help on these if you go to the wiki section of this website. Cheers, Pranab P.S.: Did not get the wink at the end!