|June 18, 2010, 13:30||
Join Date: May 2009
Posts: 39Rep Power: 9
I am simulating a T Mixer of two different reactants.
I am using Eulerian multiphase model, with 3 phases - the two reactants and air. The first phase is air, because i am assuming that at a initial state the mixer is full of air.
My doubt is i should assume this? or only two phases - the two reactants?
Another point is the continuity equation dont converge. I am not sure if it is the mesh fault, but i have a skewness lower than 0.8...
Thanks for advice
|Thread||Thread Starter||Forum||Replies||Last Post|
|Replacing mesh while running a simulation||akultane||CFX||1||November 15, 2009 14:46|
|FSI TWO-WAY SIMULATION||Smagmon||CFX||1||March 6, 2009 14:24|
|Continuous vs interrupted simulation||sega||OpenFOAM Running, Solving & CFD||4||November 3, 2008 15:29|
|reaction simulation in mixer||Min-Hua Wang||FLUENT||0||February 8, 2002 14:17|
|3-D Contaminant Dispersal Simulation||Apple L S Chan||Main CFD Forum||1||December 23, 1998 11:06|