|
[Sponsors] |
how to specify boundary conditions after slicing the fluid domain |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2020, 17:33 |
how to specify boundary conditions after slicing the fluid domain
|
#1 |
New Member
shayan
Join Date: Jul 2018
Posts: 22
Rep Power: 7 |
I am simulating a foil in Ansys Fluent. When I used inflation for meshing, orthogonal quality hits under 0.1 in trailing edge, which is not desirable. Therefore, I used slice in trailing edge in order to fix this flaw.
However, the fluid domain is divided into two distinct fluid domains. I do not know how to define boundary conditions (inlet, outlet, walls, ...) after slicing which leads to two separate domains. Can you help me how to specify boundary conditions in this case? I uploaded the geometry in attachments. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
Difficulty in calculating angular velocity of Savonius turbine simulation | alfaruk | CFX | 14 | March 17, 2017 06:08 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |