|June 30, 2010, 15:36||
Help on periodic boundary condition
Join Date: Jun 2010
Posts: 1Rep Power: 0
I am trying to simulate a 3D incompressible, laminar flow in a micro square duct. Here are input parameters:
1. Duct size: 200x200x200 micrometer.Periodic boundary condition was applied at inlet and outlet of the duct. However, when I specified the pressure drop and solved (I chose to specify the pressure drop in spite of mass flow rate), it converged after only 1 iteration and the wall shear stress is always zero. It's impossible but I don't know where this issue comes from.
I highly appreciate for any help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Theory for periodic boundary condition||Hashmi||CFX||6||November 14, 2012 17:41|
|periodic boundary condition in LES||martor||FLUENT||2||April 10, 2012 19:17|
|Periodic Boundary condition||Aerodecom||FLUENT||2||May 30, 2007 01:03|
|translational periodic boundary condition||Rola Afify||FLUENT||2||September 12, 2006 08:39|
|periodic boundary condition||dipak||Phoenics||1||November 16, 2000 05:51|