|July 29, 2010, 11:57||
Modelling of 2D Wind Turbine Blade (HAWT)
Join Date: Jul 2010
Posts: 9Rep Power: 7
Fluent won't solve my mesh as I have used a Far Field Pressure Boundary.
Should I change my mesh to an inlet/outlet type when taking air to be incompressible?
What type should my walls be?
Given that my fluid flow is the vector addition of bladespeed and windspeed, the wind vector is going to be relatively large, should I make my 2D 'tunnel' taller than I ordinarily would?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Can I use Turbogrid to mesh a wind turbine blade?||Henry Liu||CFX||10||November 10, 2011 06:41|
|[Other] ANSYS CFX-Meshing problem of a wind turbine blade||Zoe||ANSYS Meshing & Geometry||1||July 14, 2010 02:02|
|please help in simulating a wind turbine blade in 6 DOF ????....||usman naseer||Main CFD Forum||0||December 11, 2009 02:51|
|Wind Turbine Blade Geometry||SeanieB||Main CFD Forum||0||November 27, 2009 11:18|
|Wind Turbine Modelling||Neil Campbell||Main CFD Forum||1||November 10, 1998 20:03|