problem with pressure force report
I have a problem with pressure force reports.
I produced two meshes around an airfoil that one of them is fine and otherone is coarser, then after solving them by fluent viscous force terms are so close together but pressure force terms are unacceptably diffrent. I compared the velocity and pressure profiles for both cases and they were in very good accordance with each other, then I think something is wrong with pressure force reporting in fluent. everyone can test it with a simple example. now I am under doubt about the results of my solutions in last 5 years. please can somebody tell me where the problem is :eek::confused:
|All times are GMT -4. The time now is 11:24.|