URGENT: How to set fixed volume rate in a air volume?

SolarX · September 9, 2010, 16:55

I have some problems with setting a fixed volume rate inside my computational domain, so extra BCs between two other pressure BC's.
I really don't know to which boundary condition (shown in green) it must be set. Can some one give me some advise about this problem? How can I solve this!

You can see I need to set a mass_flow_inlet or pressure inlet BC, and than the air must go through the rectangular shaps by fixed volume rate (can also be a fan), it will than be extracted by a pressure_outlet upstairs with a target mass_flow_rate. The rectangular shaps represent a heating source term to this volumes, which will heat up the air raising up.

The problem is in 3D and the meshing is done well.

PLEASE HELP

SolarX · September 17, 2010, 10:25

IS THERE ANYone who has an idea about this? My master thesis is really f* up now: Frustrating!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 07:59
TRANSIENT HEAT & BOUYANCY IN CONFINED AIR	Carl	CFX	1	September 25, 2006 09:48
How to apply negtive pressure to outlet	bioman66	CFX	5	June 3, 2006 01:40
Excess Air URGENT!!!!	eric	FLUENT	1	November 28, 2003 10:20
Air Volume Change with Pressure	Walt Muller	Main CFD Forum	3	December 12, 2000 07:09

September 17, 2010, 10:25		#2
SolarX New Member EB Join Date: Aug 2010 Posts: 6 Rep Power: 15	IS THERE ANYone who has an idea about this? My master thesis is really f* up now: Frustrating!