CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Two phase T-junction pipe flow Viscous model (http://www.cfd-online.com/Forums/fluent/79980-two-phase-t-junction-pipe-flow-viscous-model.html)

Kortels September 10, 2010 06:18

Two phase T-junction pipe flow Viscous model
 
Air and water runs through an inversed-T pipe separator One tube is the inflow of air and water and the other two are the outflows. I want to measure the percentage of air and water at the two outflows in accordance with the air and water in the inflow. i am using VOF method. The problem is i can't decide which viscous model should i use. Maximum air velocity is 27m/s and water is 0,159m/s. Also max mass flow rate is 0.0106 kg/s for air and 0.049kg/s for water. I think K-epsilon is the right one. Reading the forum laminar is suitable too. Which one do you think is the best?


All times are GMT -4. The time now is 03:02.