|September 30, 2010, 12:00||
saving a picture
Join Date: Apr 2010
Posts: 30Rep Power: 8
I have a geometry with very long outlet extensions, and every time I want to plot the contours of the velocity and zoom into the geometry, the colormap overlaps the outlet extensions. If I want to save a picture of this contour plot it looks very unprofessional that the extensions of my outlets extend the colormap and are overlapped by it.
So my question is: does anybody know how I can limit the boundaries of my geometry so that even if I zoom into it, the rest would just be cut away and not get overlapped by the colormap. I tried to play a little bit with the display options, but I didn't figure it out. But I know that this is possible....
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Replay control - save picture||zboud||ANSYS Meshing & Geometry||13||June 16, 2016 14:33|
|PB: Saving mass fraction of species on two points with an udf||biget.a||FLUENT||2||July 23, 2009 03:06|
|saving window as hard copy||Lord Firestorm||FLUENT||3||July 22, 2008 09:12|
|Help!!How can I label crank angle on post picture?||Duan J Q||CD-adapco||4||October 10, 2007 08:20|
|how i can post picture here to show my question?||prayskyer||CFX||2||October 8, 2006 06:47|