|
[Sponsors] |
how to make a good three phase separator model |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 5, 2010, 22:38 |
how to make a good three phase separator model
|
#1 |
New Member
wibiario
Join Date: Nov 2010
Posts: 1
Rep Power: 0 |
how to make a good three phase separator model (gas-oil-water) in FLUENT, what is the parameter?please need help!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extract primary phase thread in VOF with 3 phases | Eric | FLUENT | 2 | July 7, 2011 02:22 |
[Commercial meshers] How to make a good Low-Re Mesh ? | Gearb0x | OpenFOAM Meshing & Mesh Conversion | 0 | February 12, 2010 04:48 |
3 phase flow | greg | FLUENT | 2 | September 8, 2006 01:14 |
How to specify one phase in Two phase (Eulerian) | CFD newer | FLUENT | 0 | February 26, 2005 20:39 |
Two-phase/ Single phase mix flow | Reza | Main CFD Forum | 1 | August 6, 2003 06:36 |