|November 17, 2010, 15:44||
Meridional Coordinates in FLUENT
Join Date: Oct 2010
Posts: 19Rep Power: 8
I have a turbomachinery set up in fluent, and I'm trying to plot pressure along the meridional (streamwise) coordinate, instead of along the radial coordinate.
I tried using the turb
otopology postprocessing, but resulting plots are looking unusual and not matching my reference plots, which is why I was trying to go through the radial to meridional conversion instead in case my errors were coming from setting up the turbomachinery system.
How can I get from the radial coordinate (My .xy files are written in terms of radial coordinates) to the meridional coordinate ?
|coordinate transform, fluent, meridional, turbomachinery|
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to open Icem mesh in Ansys Fluent?||emmkell||FLUENT||26||June 9, 2015 15:38|
|Stopping a Fluent batch job AND saving the data! Possible?||Volker Pawlik||FLUENT||7||May 22, 2014 22:30|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Fluent 6.3 32bit vs Fluent 12.0 64bit||ibex7||FLUENT||7||April 18, 2011 02:44|
|Master node in parallel computing only distirubtion||syadgar||FLUENT||1||September 8, 2009 16:41|