|November 30, 2010, 11:06||
Recorded Pressure Issue
Join Date: Nov 2010
Posts: 5Rep Power: 6
I try to record absolute pressure versus flow time in a sliding mesh simulation.
i've created a vertex in the flow to plot the absolute pressure (with 'area weighted average' function)
But the pressure signal is apparently not very good, and i don't know why!
I check time steps, discretization, mesh...
Why is there some discontinuities in the pressure signal?
I've modelized a rotor with very small impellers (like 1 mm thick), with only 6 impellers (see the black picture here : http://www.cfd-online.com/Forums/members/benjikos-albums-image-picture195-2d-geometry.jpg )
Could anyone help me?
Thanks a lot!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Using pressure outlet BC||Shreyansh||FLUENT||0||November 5, 2010 15:57|
|Setup/monitor points of pressure and force coefficients||siw||CFX||3||October 22, 2010 06:07|
|Setting pressure and velocity in inlet||Asghari||FLUENT||5||September 22, 2006 13:23|
|pressure gradient term in low speed flow||Atit Koonsrisuk||Main CFD Forum||2||January 10, 2002 11:52|
|Hydrostatic pressure in 2-phase flow modeling (CFX4.2)||HB &DS||CFX||0||January 9, 2000 14:19|