|December 7, 2010, 13:34||
Join Date: Dec 2010
Posts: 1Rep Power: 0
I am new to ANSYS Fluent, and I am teaching myself how to use it for my university project. I have been following the ANSYS tutorials from the customer portal and have found them ok so far.
I was wondering if someone could help me with somethinig though. I have learnt how to set up input/output parameters for use in the 'Design Points Workspace', but I was wondering if it is possible to set up a model dimension as a parameter. For instance: if I wanted to vary the distance of a body from the floor, could i set this distance up as an input variable?
(I am using ANSYS V12.1)
Any help would be greatly appreciated!
Thanks for your time ,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Reverse rate parameters with CHEMKIN imports||Kevin L||FLUENT||1||June 27, 2013 05:22|
|Validity EWBM parameters||luuk.thielen||Main CFD Forum||0||July 13, 2010 04:09|
|New to CFX-need explanations about mesh parameters||Cyril||CFX||3||November 24, 2006 07:33|
|expert parameters of SST model?||David||CFX||1||December 2, 2005 07:36|
|Modelling free surface waves with wave parameters||utku||FLUENT||0||December 6, 2004 09:30|